FITTING INSTRUCTIONS FOR
BLACK DUCK™ CANVAS SEAT COVERS
Fitting Instructions:
- Remove each component from packaging
- Check you have covers for seat, back, headrest & arm rest if applicable
- Each piece is identified on the inside with the product code and a “D” for drivers seat or a ‘P’ for passenger seat
- Put all drivers pieces aside
- You should be left with all passenger pieces
Fitting Back:
- Remove headrest if necessary
- Slide cover over top of seat back and down
- Replace headrest before sliding cover all the way down
- Cover should be a good tight fit
- Take front bottom flap and push through seat to rear
- Pull tight and attach to Velcro inside rear of cover
Fitting Base:
- Slide seat base onto seat ensuring it is clear of all levers or buttons
- Push rear flap through seat to back
- Pull both side flaps tight around seat base, ensuring clear of levers etc.
- Attach to centre flap with the attached Velcro
- If included, pull straps through under seat clearing all tracks and fittings. Pull tight and fasten to opposite side Test movement of seat to ensure nothing is obstructed
- As you use you vehicle, Black Duck™ Seatcovers will mould to the shape of your seats
- You may find you need to re-tension the Velcro fasteners occasionally
Then proceed to fit Driver’s cover and rear seats if applicable
Black Duck™Canvas Seat covers must not be fitted to sets containing side impact airbag components. Black Duck™ Canvas Products accepts no responsibility or liability if this warning is not adhered to. |